Alwazour Technical
AR Request a quote on WhatsApp

AI-generated representative footage — not a photograph of this exact product

In stock

SFTP Cat7 Cable - 300m drum

CBL-CAT7-SFTP-300

Fully shielded Cat7 cable in a pull box, for runs that share a tray with power. Conductor 0.57mm. Solid copper conductor.

Standard
cat7
Type
Network
Shielded
Yes
Length
300 m

From the cable reel

Scroll to explore

T568A / T568B

Connector anatomy

RJ45 (8P8C)

  • 01 8 gold contacts The eight blades pierce the wire insulation to touch the copper directly — four pairs, two for transmit and two for receive.
  • 02 Locking clip Snaps inside the socket so vibration cannot pull the plug out. A snapped clip is the number-one cause of intermittent network drops.
  • 03 T568A vs T568B Two equivalent wiring standards: T568A puts the green pair on pins 1-2 and orange on 3-6; T568B swaps them. Performance is identical as long as both ends of the same cable use the same standard.
  • 04 Strain-relief boot Stops the wires flexing where they leave the plug — the exact point most cables fail.
  • 05 Outer jacket The outer sheath protecting the conductors inside from abrasion and moisture.

Technical illustration, not a photo of the actual product

How it works

Cable construction

Four pairs, each twisted at a different rate from its neighbour. The twisting makes both wires of a pair pick up identical noise, which then cancels when the far end subtracts them. That alone is why networking works over a hundred metres.

This cable is shielded: a grounded conductive layer around the pairs, which earns its place near mains cable or motors.

Technical illustration, not a photo of the actual product

From the published standard

How it works

Four copper pairs, each twisted at a different rate from its neighbour. The twisting makes both wires of a pair pick up identical noise, which then cancels when the far end subtracts them — that alone is why networking works over a hundred metres. The 100 metre figure in TIA-568 is a limit on the whole channel, meaning the permanent run plus the short patch leads at each end, not on the cable alone.

Pairs
4 twisted pairs, 100 ohm ±15% characteristic impedance
Channel limit
100 m total, including patch leads at both ends
Governing standard
ANSI/TIA-568

This information comes from published sources about this type of product, not from the supplier.

Applications

Technical specifications

Standardcat7
TypeNetwork
ShieldedYes
Length300 m

Not sure this is the right part?

Ask on WhatsApp, and get an answer from a team that actually knows the stock.

Request a quote on WhatsApp
In stock Request a quote on WhatsApp
WhatsApp

Type to search